Mã lỗi máy sấy lạnh và cách khắc phục

Heat pump Error Codes

Mã lỗi Heat pump

If an error occurs, one of more of the LEDs on the display (see “Components” for their location) will flicker.

Nếu xảy ra lỗi, một trong số các đèn LED trên màn hình (xem thành phần cơ bản và vị trí của chúng) sẽ nhấp nháy

As a protection strategy, the unit stops operating (and the LED turns off). If the unit is turned on before the problem is resolved, the LED will resume flickering and the unit will stop operating again.

Như một phương pháp bảo vệ, thiết bị sẽ ngừng hoạt động và đèn LED tắt. Nếu thiết bị được bật trước khi sự cố được giải quyết, đèn LED sẽ tiếp tục nhấp nháy và thiết bị sẽ ngừng hoạt động trở lại.

Heat pump Error Codes
Mã lỗi Heat pump

4-Way Cassette-Indoor, 1-Way Cassette-Indoor, Mini-4-Way Cassette-Indoor, Convertible Ceiling-Floor-Indoor, High Wall-Indoor, Big Duct-Indoor, Slim, MSP, and HSP Duct-Indoor, Mini-Outdoor.

Diagnostic LEDs for the heat pump:

Đèn LED chuẩn đoán cho bình bảo ôn

Error CodesProblem/ Vấn đề. 
E121Indoor temperature sensor error (shorted or open)/ Lỗi cảm biến nhiệt độ bình bảo ôn (ngắt mạch hoặc lỏng zắc cắm). Cách xử lý: Kiểm tra cảm biến nhiệt bình bảo ôn. 
E122Evap-in sensor error (shorted or open)/ Lỗi cảm biến Evap-in (ngắt mạch hoặc lỏng zắc cắm)
E123Evap-out sensor error (shorted or open)/ lỗi cảm biến Evap-out (ngắt mạch hoặc lỏng zắc cắm)
E126Discharge sensor error (shorted or open)/ Lỗi cảm biến phóng điện (ngắt mạch hoặc lỏng zắc cắm)
E154Indoor fan error/ lỗi quạt bình bảo ôn.
E221Outdoor temperature sensor error (shorted or open)/ Lỗi cảm biến nhiệt độ heat pump.
E237Condenser sensor error (shorted or open)/ Lỗi cảm biến dàn ngưng
E251Discharge sensor error/ lỗi cảm biến phóng điện.
E101No communication between indoor and outdoor units for 2 minutes/ không kết nối giữa heat pump và bình bảo ôn trong vòng 2 phút
E102Communication error received from outdoor unit/ lỗi kết nối thông tin liên lạc từ heat pump.
E2023-minute tracking error on outdoor unit/ lỗi theo dõi 3 phút trên heat pump
E201Communication error after tracking due to non-matching quantity of installed indoor units/ Lỗi kết nối sau khi theo dõi số lượng không phù hợp của bình bảo ôn được cài đặt.
E108Error due to repeated communication address/ Lỗi địa chỉ liên lạc bị lặp đi lặp lại.
E109Communication address not confirmed/ Địa chỉ liên lạc không được xác nhận.
E151Error due to opened EEV (2nd detection)/ lỗi do EEV đã mở (phát hiện lần 2)
E152Error due to closed EEV (2nd detection)/lỗi do EEV đã hỏng (phát hiện lần 2)
E128Evap-in sensor is loose/ Cảm biến Evap-in bị hỏng
E129Evap-out sensor is loose/ Cảm biến Evap-out bị hỏng
E198Thermal switch error (open)/ Lỗi công tắc nhiệt (mở)
E241Condenser mid-sensor is loose/ Lỗi cảm biến giữa dàn ngưng
E554Refrigerant leakage (2nd detection)
E450Abnormally high temperature on condenser (2nd detection)
E451Low pressure switch (2nd detection)/ Rò rỉ môi chất lạnh (phát hiện lần 2)
E416Abnormally high discharge air temperature on outdoor unit (2nd detection)/ Nhiệt độ không khí xả cao bất thường trên heat pump (phát hiện lần 2)
E559Indoor unit operation stopped due to unconfirmed error on outdoor unit/ Dừng hoạt động bình bảo ôn do lỗi chưa được xác định trên heat pump.
E425Reverse phase detection error/ Lỗi phát hiện ngược pha
E403Compressor operation stop due to freeze detection(6th detection)/ Dừng hoạt động của máy nén do phát hiện đóng băng (phát hiện thứ 6)
E301High pressure sensor is loose/ Lỗi cảm biến áp suất cao
E306Low pressure sensor is loose/ Lỗi cảm biến áp suất thấp
E428Outdoor unit compression ratio error/ Lỗi tỷ lệ nén của heat pump
E413Outdoor sump down_1 prevention control/ Kiểm soát phòng ngừa thiết bị hứng dầu heat pump
E410Compressor operation stopped due to low pressure sensor prevention control/ Hoạt động của máy nén bị dừng do điều khiển cảm biến áp suất thấp
E180Simultaneous opening of cooling/heating MCU solenoid valve (1sst detection)/ van tiết lưu điện từ MCU làm nóng nước (phát hiện 1 giây)
E181Simultaneous opening of cooling/heating MCU solenoid valve (2nd detection)/ Van tiết lưu điện từ MCU làm nóng nước(phát hiện lần 2)
E153Float switch (2nd detection)/ công tắc phao (phát hiện lần 2)
E162EEPROM error/ Lỗi EEPROM
E163EEPROM option error/ Lỗi tùy chọn EEPROM
E164Incompatible indoor unit error/ Lỗi bình bảo ôn không tương thích

Contact Me on Zalo
Chat

Hotline: 0965139148